From the first symptom to the final fix, these are the specific furnace repair services our Sharon-area crews are equipped for.
Ignitor & Pilot Light Repair
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. This is one of the most requested furnace repair calls we get across Sharon, WI.
Gas Valve Diagnostics
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. Techs handling gas valve diagnostics carry the specific parts and tools this job calls for, not a generic kit.
Heat Exchanger Inspection & Repair
A cracked heat exchanger is a carbon monoxide risk and gets flagged immediately with the furnace shut down if needed. Techs handling heat exchanger inspection & repair carry the specific parts and tools this job calls for, not a generic kit.
Blower Motor & Limit Switch Repair
We test motor amp draw against rated spec before replacement. Techs handling blower motor & limit switch repair carry the specific parts and tools this job calls for, not a generic kit.
Flue & Venting Repair
We inspect the full flue run, not just the connection at the furnace. Techs handling flue & venting repair carry the specific parts and tools this job calls for, not a generic kit.
Thermostat & Control Board Diagnostics
A furnace that won't respond to the thermostat at all sometimes traces to a control board fault rather than the burner assembly. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.
